My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?

Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.

  • MinorLaceration@lemmy.worldEnglish
    2·
    8 months ago

    100% agree on the bed level sensor. I have a BL touch and it is far and away the best upgrade for my ender 3v2.

    I’d definitely recommend anyone adding a touch sensor play around with different firmwares. I was running a very buggy firmware for about 2 years and didn’t realize I could just find something that works better. My new firmware works so much better and has so many more features, all in a $0 upgrade.